This is a fine example of an usual wall timepiece made in North Attleboro, Massachusetts. This case design features a large round head, a straight sided waist section and an circular shaped lower box. It is affectionally called the “Dumb bell” form in the trade. This case is die stamped by the case maker “DLW” on the lower bow. DLW stands for David L Williams. Williams was a cabinetmaker and clock manufacturer in the region. Having the case signed by him is a nice bonus for the clock collector. This case measures approximately 33 inches. The upper bezel measures 14.25 inches in diameter, the waist is approximately 8 inches long and the lower bezel measures 10.25 inches in diameter. This case is approximately 4.25 inches deep. The case wood is cherry and retains much of its original graining. The graining was applied to simulate the figure found in rosewood. This case has been carefully cleaned in is in very good condition. Both of the tablets have been professionally repainted in the traditional colors of black and gold. The upper wooden bezel opens to access the painted zinc dial which measures 12.75 inches across. The 11 inch diameter closed time track features Roman numerals. The time is indicated with open moon hands. Behind the dial is a brass movement that is weight driven. It is designed to run eight days on a full wind. This movement is designed with a recoil escapement, alternate train, and straights movement pillars. The plates that frame the movement are rectangular in form. The rear plate is mounted to the pine backboard with two screws through the back plate. The movement also sits on a seat board which also serves double duty as a weight stop. Other traditional Hatch features found on this clock include, the shape of the keystone, the construction of the pendulum having a rounded wood rod and a detached bob. This example retains its original cast iron weight and was made circa 1860. This is a very attractive example.